Learn
Arthrosamid vs hyaluronic acid (gel) injections
“Gel shots” usually means hyaluronic acid viscosupplementation: Synvisc, Durolane, Monovisc, and similar products. They lubricate the joint until the body absorbs them. Arthrosamid is also a gel, but a fundamentally different one: non-degradable, integrating with the joint lining, given once.
| Dimension | Hyaluronic acid | Arthrosamid |
|---|---|---|
| What it is | A biodegradable lubricating gel (hyaluronic acid), sold under brands such as Synvisc, Durolane, and Monovisc. | A non-degradable polyacrylamide hydrogel (2.5% polyacrylamide, 97.5% water). |
| How it works | Temporarily supplements the joint fluid to improve lubrication. | Integrates with the synovial tissue lining the knee and cushions the joint. |
| How often | Given as a single shot or a short series, and typically repeated every 6 to 12 months because the gel is absorbed. | A single injection; the hydrogel is not absorbed. |
| How long relief typically lasts | Up to around six months when it works, fading as the gel breaks down. | Pain improvement after a single injection has been maintained in published follow-up out to five years. |
| Evidence picture | Clinical guidelines differ on how strongly they recommend it for knee osteoarthritis. | Peer-reviewed studies with follow-up data extending to five years. |
Arthrosamid sources: Manufacturer instructions for use (IFU) and patient brochure. Bliddal et al. 2024, Osteoarthritis & Cartilage 32(6):770–771; Bliddal et al. 2025 (5-year follow-up, WCO-IOF-ESCEO).
The pattern over five years
Illustrative pattern, not patient data: repeat-injection intervals vary. Arthrosamid lane: published follow-up with pain improvement maintained out to five years after a single injection.
The practical difference: absorbed vs integrated
Simplified illustration of the difference in behaviour inside the joint.
Hyaluronic acid is a natural component of joint fluid, and injecting it tops up lubrication for a while; because it is biodegradable, the effect fades as the product breaks down, and courses are commonly repeated every 6 to 12 months. Arthrosamid is 2.5% cross-linked polyacrylamide and 97.5% water. It is not absorbed: it integrates with the synovial tissue lining the knee and cushions the joint, which is why it is given as a single injection, with pain improvement in published follow-up maintained out to five years.
Whether a repeat-course lubricant or a single longer-horizon injection suits you better is a physician decision. Start with the two-minute candidacy check, or compare cortisone and PRP.
Common questions
Is Arthrosamid just another gel injection?
It is a gel, but the similarity ends there. Hyaluronic acid gels are absorbed by the body, which is why they are repeated. Arthrosamid is a non-degradable hydrogel that integrates with the tissue lining the joint and stays in place.
I have had Synvisc or Durolane before. Can I have Arthrosamid?
Yes, in most cases. Hyaluronic acid products are absorbable, so a previous course does not rule you out. (A previous NON-absorbable injectable in the knee is a contraindication; the physician reviews this at consultation.)
Why do gel shots stop working after a few months?
Hyaluronic acid is biodegradable: the body gradually breaks it down and the lubricating effect fades with it, which is why courses are repeated every 6 to 12 months.
There is no cure for osteoarthritis. Treatment may reduce or relieve knee pain, but symptoms may not improve and in some cases may worsen. Individual results vary.